2151 KB37 KB200020242014Akkurt, Adnanletnik:48številka:5str. 725-734COBISSID:1096362ISSN:1580-2949URN:URN:NBN:SI:doc-M4BLNDKWenInštitut za kovinske materiale in tehnologijeMateriali in tehnologijeabrasive water jetabrazijsko rezanje z vodnim curkomcutting methodslastnosti površinemetode rezanjasurface propertiesExperimental investigation of the surface properties obtained by cutting brass-353 (alpha + beta) with an abrasive water jet and other cutting methods| Preiskava lastnosti površine medenine 353 (alfa+beta) po rezanju z abrazijskim vodnim curkom in drugimi metodami rezanja|In the manufacturing industry different methods are used to provide the fastest, cheapest and the most cost-effective way of facilitating the process of cutting with the minimum surface deformation. Apart from the conventional methods, non-traditional methods such as abrasive water jet (AWJ), laser, plasma, underwater plasma and wire erosion are used intensely for the cutting of hard-to-cut materials and products. Research has been conducted on the AWJ method. Brass materials are widely used in industry. In this study the results of the cutting process for brass material with AWJ were investigated. Based on the results the ideal cutting method for the investigated material was found to be AWJV industriji se uporabljajo različne metode za hitro, cenejše in stroškovno bolj ugodne metode rezanja z minimalno deformacijo površine. Poleg navadnih metod za rezanje trdih materialov in proizvodov se uporabljajo tudi netradicionalne, kot je abrazijsko rezanje z vodnim curkom (AWJ), laser, plazma, podvodna plazma in žična erozija. Izvršene so bile raziskave AWJ. Medenina se pogosto uporablja v industriji. V tej študiji je bil preiskan postopek rezanja medenine z AWJ. Glede na dobljene rezultate je ugotovljeno, da je za preiskovani material najboljša metoda abrazijsko rezanje z vodnim curkomTEXTznanstveno časopisjejournalsSlovenian National E-content AggregatorNational and University Library of SloveniaInštitut za kovinske materiale in tehnologije