{"?xml":{"@version":"1.0"},"edm:RDF":{"@xmlns:dc":"http://purl.org/dc/elements/1.1/","@xmlns:edm":"http://www.europeana.eu/schemas/edm/","@xmlns:wgs84_pos":"http://www.w3.org/2003/01/geo/wgs84_pos","@xmlns:foaf":"http://xmlns.com/foaf/0.1/","@xmlns:rdaGr2":"http://rdvocab.info/ElementsGr2","@xmlns:oai":"http://www.openarchives.org/OAI/2.0/","@xmlns:owl":"http://www.w3.org/2002/07/owl#","@xmlns:rdf":"http://www.w3.org/1999/02/22-rdf-syntax-ns#","@xmlns:ore":"http://www.openarchives.org/ore/terms/","@xmlns:skos":"http://www.w3.org/2004/02/skos/core#","@xmlns:dcterms":"http://purl.org/dc/terms/","edm:WebResource":[{"@rdf:about":"http://www.dlib.si/stream/URN:NBN:SI:DOC-RACOINNT/57c0a2ba-5982-4cf0-83b8-d2e46df3536d/PDF","dcterms:extent":"1454 KB"},{"@rdf:about":"http://www.dlib.si/stream/URN:NBN:SI:DOC-RACOINNT/e7bf8a0a-92a1-4b2d-9aea-5b06a374f4ee/TEXT","dcterms:extent":"31 KB"}],"edm:TimeSpan":{"@rdf:about":"1999-2025","edm:begin":{"@xml:lang":"en","#text":"1999"},"edm:end":{"@xml:lang":"en","#text":"2025"}},"edm:ProvidedCHO":{"@rdf:about":"URN:NBN:SI:DOC-RACOINNT","dcterms:isPartOf":[{"@rdf:resource":"https://www.dlib.si/details/URN:NBN:SI:spr-6QOUKQ9A"},{"@xml:lang":"sl","#text":"Strojniški vestnik"}],"dcterms:issued":"2014","dc:creator":["Boltežar, Miha","Rovšček, Domen","Slavič, Janko"],"dc:format":[{"@xml:lang":"sl","#text":"številka:3"},{"@xml:lang":"sl","#text":"letnik:60"},{"@xml:lang":"sl","#text":"str. 187-194, SI 35"}],"dc:identifier":["ISSN:0039-2480","COBISSID:13401371","URN:URN:NBN:SI:doc-RACOINNT"],"dc:language":"en","dc:publisher":{"@xml:lang":"sl","#text":"Zveza strojnih inženirjev in tehnikov Slovenije et al."},"dc:subject":[{"@xml:lang":"sl","#text":"akustično vzbujanje"},{"@xml:lang":"sl","#text":"enojen odziv"},{"@xml:lang":"sl","#text":"majhne in lahke strukture"},{"@xml:lang":"sl","#text":"metoda z uglašenim sinusom"},{"@xml:lang":"sl","#text":"normiranje lastnih oblik"},{"@xml:lang":"sl","#text":"obratovalna modalna analiza"}],"dcterms:temporal":{"@rdf:resource":"1999-2025"},"dc:title":{"@xml:lang":"sl","#text":"Tuned-sinusoidal method for the operational modal analysis of small and light structures|"},"dc:description":[{"@xml:lang":"sl","#text":"Small and light structures have some distinctive features that intensify the difficulties when measuring their modal parameters. The mass that is added to the structure by the sensors cannot be neglected and the resonant frequencies are usually relatively high. As a result, a wide frequency range of measurements is needed. There are also difficulties with ensuring the proper excitation, so that all the measured modes are excited well and that at the same time the excitation level is not too large, which would cause a larger response of the structure than the measuring ranges of the sensors can cover. In this study an innovative method for the operational modal analysis of small and light structures is presented. The method is non- contact; therefore, there is no added mass of the sensors to the structure. The structure is acoustically excited with a pure sine signal that is tuned to each resonant frequency. A single response measurement with the laser Doppler vibrometer in individual points is needed to determine the modal parameters. A mass-change strategy is used for the mass-normalisation of the measured mode shapes. The main contribution of the presented method compared to other similar methods is that the mode shapes are better accentuated (due to the sine excitation), which can improve the results of the modal analysis on small and light structures, where the response of the structure is weak. The method is also easy to perform, because only a single response measurement is needed for each point and the excitation force does not need to be measured. The presented method gives accurate results, and this was confirmed with a comparison of the experimental and the numerical results on a sample of simple geometry"},{"@xml:lang":"sl","#text":"Kljub temu, da obstaja že mnogo eksperimentalnih metod za določanje modalnih parametrov (lastnih frekvenc, lastnih oblik in dušenja), se pri izvajanju teh metod pogosto pojavijo težave, ko se skuša analizirati razmeroma majhne in lahke strukture. Razlog se skriva v tem, da se pri takih strukturah z običajnimi merilnimi instrumenti (silomer, pospeškomer) na strukturo doda masa in s tem se spremenijo njene modalne karakteristike. Hkrati pa imajo take strukture pogosto zelo visoke lastne frekvence, zaradi česar je potrebna meritev v širokem frekvenčnem področju in je treba temu prilagoditi tudi izbiro senzorjev. V poimenovanju majhne in lahke strukture so torej zajete vse strukture, pri katerih se zaradi njihove majhne velikosti ali mase pojavijo težave pri določanju modalnih parametrov zaradi dodane mase senzorjev in visokih lastnih frekvenc"}],"edm:type":"TEXT","dc:type":[{"@xml:lang":"sl","#text":"znanstveno časopisje"},{"@xml:lang":"en","#text":"journals"},{"@rdf:resource":"http://www.wikidata.org/entity/Q361785"}]},"ore:Aggregation":{"@rdf:about":"http://www.dlib.si/?URN=URN:NBN:SI:DOC-RACOINNT","edm:aggregatedCHO":{"@rdf:resource":"URN:NBN:SI:DOC-RACOINNT"},"edm:isShownBy":{"@rdf:resource":"http://www.dlib.si/stream/URN:NBN:SI:DOC-RACOINNT/57c0a2ba-5982-4cf0-83b8-d2e46df3536d/PDF"},"edm:rights":{"@rdf:resource":"http://rightsstatements.org/vocab/InC/1.0/"},"edm:provider":"Slovenian National E-content Aggregator","edm:intermediateProvider":{"@xml:lang":"en","#text":"National and University Library of Slovenia"},"edm:dataProvider":{"@xml:lang":"sl","#text":"Univerza v Ljubljani, Fakulteta za strojništvo"},"edm:object":{"@rdf:resource":"http://www.dlib.si/streamdb/URN:NBN:SI:DOC-RACOINNT/maxi/edm"},"edm:isShownAt":{"@rdf:resource":"http://www.dlib.si/details/URN:NBN:SI:DOC-RACOINNT"}}}}